High Pressure Regulator Back Fire

[clay]

I replaced the HPR and that did the trick, Thanks everyone.

[siai47]

Re: High Pressure Regulator Back Fire

Most likely the high pressure regualtor has failed and will need to be replaced. The factory part can be replaced with an Impco HPR-3600 which can be purchased for a lot less money than the original from several different sources. There are a couple of good threads on this site about this including a very detailed step-by-step instruction on replacement.

[Highmarker]

Re: High Pressure Regulator Back Fire

I second siai47's comment. The HPR needs to be replaced.

[dovh49]

Re: High Pressure Regulator Back Fire

Apparently this place sells them for cheap. I'll post it in the sticky too. Don't know how long it takes to get but it should cost ~$161. Send me a PM when you find out how long it takes to get to you if you go with this one.

Equipment & Systems Engineering, Inc.

14260 SW 136th ST. # 4

Miami, Florida 33186

Tel: 305 378 4101

Fax: 305 378 4121